Simple car camera 360 degree car camera 4 to 1 Intelligent car camera system
Please pay attention that this model is a simple 360 switcher, it can not show all image at the same time.
4 RCA video input (rear /front/ right/ left), 1 RCA video output
2 ways to activate cameras: Auto triggered by car lights or remote controller
Integrated power filter offers clean 12V for cameras
Compact desgin, easy installation
1. Product Description
4 to 1 Intelligent 360 Panoramic Switcher is supposed to add more video
inputs for cameras when it’s connected with video interface for for
different car models.It’s sort of DIY solution for customers with easy
installation.The switcher can work with video interface,aftermarket Car
DVD or Monitor.
1). Four video inputs :Left view, Right view, Front view and reverse view.
There is + 12V power supply for each video input
2). Four video outputs share with one video channel with the same power
3).When each camera gets power supply from the corresponding car
lamp,the display could show the correct video channel by turn on left
and right indicator or back up. When you turn “R” to other gear,The
display will show front view for 7 seconds(It’s optional).After 7
seconds,it gets back to UI interface.
Cable color refers to: 12V power + (Red cable),GND - (Black
cable),Left indicator (Blue cable),Right indicator (Green cable) and
Back-up lamp (White cable)
4).The product itself has designed the product power supply protection
circuit and the camera supply protection circuit, carries on the protection
to the camera and the vehicle circuit.
5).You can also use remote control to select camera view.
6).Wide voltage VCC 8--16V;If it’s applied in the truck,you can use a 4V
to 12V transformer.
3. Package Contents
Standard contents: 4 to 1 Intelligent 360 Panoramic Switcher, remote
control, manual book.
4.Remote control set LED light instructions (support only with
remote control products)
1).When press any button, the LED of the indicator receiver and the
remote controller will flicker, indicating that the receiving and receiving
2).Press the remote control M key for 5s, receiver LED flash 2 times,
indicating mode 1 "auto-turn front view after rear view" and mode 2 "exit
when rear view is closed" function. Switching work is done. Finally,
restart the power supply and use it.
3).Remote control code mode, press the receiver button for 3S , the
receiver's LED lights turns off. Then press any button, the receiver's LED
flash twice, indicating that the code is completed, and finally restart the
|Prev and Next product buttons||Use Config Settings|